12V 1400A Intelli-Start Professional Lithium Jump Starter and Power Bank

Rapid Recharge Technology

Replenishes discharged power in 40 seconds, when left connected to vehicle’s battery

• We offer free shipping on orders over $150 AUD (after discounts, before shipping).
• Exclusions: Free shipping does not apply to Dangerous Goods or Bulky Goods.
• Orders Under $150: A flat $12.99 AUD shipping rate applies.
• Dispatch Timeframes: Orders are typically dispatched within 1 business day.
• Delivery Timeframes: Estimated delivery is 2–5 business days after dispatch. Actual delivery times vary based on your location within Australia. Deliveries outside metropolitan areas may take longer.

CAN THE IS1400 JUMP START VEHICLES AT BELOW 0°C?

If the IS1400 operates at temperatures below 0°C, its jump start rated performance will be reduced but it will start vehicles with lower clamp output requirements.

TIP Turn on the flood lights to warm up the jump starter at the expense of battery charge.

WHY DIDN’T MY IS1400 START MY VEHICLE?

There could be a number of reasons why the IS1400 did not start your vehicle.
Check the following:
• Ensure you have firm clamp connection to battery posts and the battery posts are clean from grease and dust build-up.
• Ensure the IS1400 is fully charged. Press the POWER button to check the battery state of charge.
• Ensure you have followed the correct operating procedure. Refer to page 7 (JUMP STARTING INSTRUCTIONS).
• Ensure the vehicle operates at 12V DC.
• If the ambient temperature is low (<15°C), the jump starting performance will be reduced. Repeat the jump start routine 1–3 times as the battery performance will improve with each concurrent jump start.
• Ensure the vehicle being jump started does not require a clamp output of greater than 500A.

WHAT IS PEAK AMPS?

Peak amps is the maximum current the battery in the IS1400 can produce.

WHAT IS CLAMP POWER?

Clamp power is the maximum current available at the IS1400 clamps.

Download Instruction Manual