IS920C
INTELLI-START
12V 900A Intelli-Start Emergency Lithium Jump Starter and Power Bank
or 4 payments of A$49.75 with
IS920C
RAPID RECHARGE TECHNOLOGY
Recharges the jump starter from the vehicle in just 40 seconds
- We offer free shipping on orders over $150 AUD (after discounts, before shipping).
- Exclusions: Free shipping does not apply to Dangerous Goods or Bulky Goods.
- Orders Under $150: A flat $12.99 AUD shipping rate applies.
- Dispatch Timeframes: Orders are typically dispatched within 1 business day.
- Delivery Timeframes: Estimated delivery is 2–5 business days after dispatch. Actual delivery times vary based on your location within Australia. Deliveries outside metropolitan areas may take longer.
WHY DIDN’T MY JUMP STARTER START MY VEHICLE?
There could be a number of reasons why the jump starter did not start your vehicle.
Check the following:
1. Ensure the jump starter battery is fully charged. Refer to (‘Battery Status Indicator’).
2. Ensure you have followed the correct operating procedure. Refer to (‘Jump Starter Instructions’).
3. Ensure the vehicle operates on 12V DC.
4. Ensure the vehicle being jump started is within the specified engine size for the jump starter. For IS920C up to most 6.0 litre petrol vehicles and for IS1220C up to most 7.0 litre petrol vehicles and 4.5 litre diesel vehicles.
CAN I LEAVE MY JUMP STARTER CONNECTED TO THE CAR AFTER IT HAS STARTED?
Yes. The jump starter uses Rapid Recharge Technology (RRT) to rapidly recover charge from the vehicle’s alternator. Leaving the clamps connected for at least 40 seconds after starting will recharge the jump starter to 100% of its original charge status. Once fully charged, RRT will shut off and you can disconnect the black clamp and then the red clamp.
HOW OFTEN SHOULD I CHARGE MY JUMP STARTER?
The jump starter uses lithium technology, which self-discharges very slowly. To be safe, it should be charged at least once a year to ensure it is ready in an emergency.
CAN I CHARGE THE JUMP STARTER AND USE THE USB OUTPUT AT THE SAME TIME?
Yes. The USB output can be used while charging via the USB input. However, the USB output is disabled if the jump starter is charging using RRT.
WHAT IS PEAK AMPS?
Peak amps is the maximum current the battery in the jump starter can produce.
WHAT IS CLAMP POWER?
Clamp power is the maximum current available at the clamps to start the vehicle.
WHY ISN’T MY JUMP STARTER CHARGING?
The jump starter will not charge or perform Rapid Recharge above 45°C. If the alternator voltage is above 14.6V or faulty, Rapid Recharge will not work.
Feature spotlight
What sets this apart
RAPID RECHARGE TECHNOLOGY
Recharges the jump starter from the vehicle in just 40 seconds
POWER BANK
Powerbank USB Type-A, allows charging of phones and other portable devices on the go. Now with USB Type-C charging port to charge the unit.
LED WORK LIGHT
A powerful 0.5 Watt/ 180 lumen LED flood light with SOS function
SPARK-FREE CLAMPS
The premium clamps won’t spark if they’re incorrectly connected, and they won’t damage the vehicle’s electronics
Engineered to last
Technical Specs
KEY SPECIFICATIONS
RECHARGE CABLE
1m long USB to Type C
USB OUTPUT
2.1A, 5.0V
USB LOW VOLTAGE DISCONNECT
10.5V
OUTLETS
2.1A Type C charging port 3rd party 10W 240V AC USB adaptors can be used. (Not provided)
BATTERY CAPACITY
1.6Ah at 12.8V 6,400mAh at 3.2V 20.48Wh
BATTERY CYCLES
1800
BATTERY CHEMISTRY
Lithium (LiFePO4)
CLAMP POWER
12V 240A maximum current available at the clamps
PEAK AMPS
900A
RECHARGING VIA
12V DC Charging: 12V to 5V 2.1A USB charger (provided) DC Charging: 4 hours
RECHARGING SOURCE
RRT via vehicle starting battery
VOLTAGE
12V Only
OPERATING TEMPERATURE
-20°C to 60°C
OPERATING TEMPERATURE (CHARGING)
0°C to 45°C
STORAGE TEMPERATURE (LONG TERM)
-10°C to 60°C
APPLICATION
Emergency only
TYPES OF VEHICLE
Starts 12V vehicles up to 6.0L petrol
VEHICLE VOLTAGE RANGE
0V to 15V
JUMP STARTER LEADS - LENGTH
Positive: 310mm Negative: 270mm
JUMP STARTER LEADS - CABLE
8mm² – 8 AWG
OVERLOAD PROTECTION
MCU controlled with electronic switch
POLARITY PROTECTION
MCU controlled with electronic switch
NO. OF EMERGENCY JUMP STARTS
Unlimited with Rapid Recharge Technology®
IP RATING
IP53 (Rain Proof) with covers over the ports
DIMENSIONS & WEIGHT
Dimensions
178 x 92 x 48mm
Weight
600g
WARRANTY
Warranty
2 Year Warranty
RECHARGE CABLE
1m long USB to Type C
USB OUTPUT
2.1A, 5.0V
USB LOW VOLTAGE DISCONNECT
10.5V
OUTLETS
2.1A Type C charging port 3rd party 10W 240V AC USB adaptors can be used. (Not provided)
BATTERY CAPACITY
1.6Ah at 12.8V 6,400mAh at 3.2V 20.48Wh
BATTERY CYCLES
1800
BATTERY CHEMISTRY
Lithium (LiFePO4)
CLAMP POWER
12V 240A maximum current available at the clamps
PEAK AMPS
900A
RECHARGING VIA
12V DC Charging: 12V to 5V 2.1A USB charger (provided) DC Charging: 4 hours
RECHARGING SOURCE
RRT via vehicle starting battery
VOLTAGE
12V Only
OPERATING TEMPERATURE
-20°C to 60°C
OPERATING TEMPERATURE (CHARGING)
0°C to 45°C
STORAGE TEMPERATURE (LONG TERM)
-10°C to 60°C
APPLICATION
Emergency only
TYPES OF VEHICLE
Starts 12V vehicles up to 6.0L petrol
VEHICLE VOLTAGE RANGE
0V to 15V
JUMP STARTER LEADS - LENGTH
Positive: 310mm Negative: 270mm
JUMP STARTER LEADS - CABLE
8mm² – 8 AWG
REVERSE POLARITY PROTECTION
OVERLOAD PROTECTION
MCU controlled with electronic switch
POLARITY PROTECTION
MCU controlled with electronic switch
NO. OF EMERGENCY JUMP STARTS
Unlimited with Rapid Recharge Technology®
IP RATING
IP53 (Rain Proof) with covers over the ports
Dimensions
178 x 92 x 48mm
Weight
600g
Warranty
2 Year Warranty
Everything you need
What's in the box?
12V Jump Starter Unit
Spark-Free Clamps
Reverse polarity protected clamps for safe, foolproof connections.
USB-C to USB-C Charging Cable
Use to recharge the jump starter or to top up your devices on the go.
12V USB-A Adapter
Plugs into any 12V socket for versatile charging.
Storage bag
Storage bag for the jump starter and charging leads .
Instruction Manual
Step-by-step instructions and safety tips
Packaged Product
In the wild
The Feed
Join the community
