IS3000
INTELLI-START
12/24V 3000A Intelli-Start Industrial Jumpstarter
or 4 payments of A$611.25 with
IS3000
RAPID RECHARGE TECHNOLOGY
Recharges the jump starter from the vehicle in just 40 seconds
- We offer free shipping on orders over $150 AUD (after discounts, before shipping).
- Exclusions: Free shipping does not apply to Dangerous Goods or Bulky Goods.
- Orders Under $150: A flat $12.99 AUD shipping rate applies.
- Dispatch Timeframes: Orders are typically dispatched within 1 business day.
- Delivery Timeframes: Estimated delivery is 2–5 business days after dispatch. Actual delivery times vary based on your location within Australia. Deliveries outside metropolitan areas may take longer.
WHY DOES MY JUMP STARTER TAKE SO LONG TO CHARGE ON THE DOCK?
Lower charging rate extends the battery life. The built-in charging circuit provides gentle charge with cell-balancing for the internal Lithium Iron Phosphate (LiFePO?) battery.
CAN THE JUMP STARTER JUMP START VEHICLES AT TEMPERATURE LOWER THAN 0°C?
If the jump starter operates at temperatures below 0°C, its jump start rated performance will be reduced but it will start vehicles with lower clamp output requirements.
WHY DIDN’T MY JUMP STARTER START MY VEHICLE?
There could be a number of reasons why the jump starter did not start the vehicle.
Check the following:
• Ensure you have firm clamp connection to battery posts and the battery posts are clean from grease and dust build-up.
• Ensure the jump starter is fully charged. Press the POWER button to check the battery state of charge.
• Ensure you have followed the correct operating procedure. Refer to JUMP STARTING INSTRUCTIONS.
• Ensure the vehicle operates at 12V DC or 24V DC.
• If the ambient temperature is low (<15°C), the jump starter performance will be reduced. Repeat the jump start routine 1–3 times as the battery performance will improve with each concurrent jump start.
• Ensure the vehicle being jump started does not require a clamp output of greater than 1000A for 12V DC batteries and 850A for 24V DC batteries for IS3000 or 1500A for 12V DC batteries and 1000A for 24V DC batteries for IS5000 in order to jump start the vehicle.
• If possible, connect clamps as close as possible to the starter motor without going through long cables.
WHAT IS PEAK AMPS?
Peak amps is the maximum current the battery in the jump starter can produce.
WHAT IS CLAMP POWER?
Clamp power is the maximum current available at the clamps.
Feature spotlight
What sets this apart
RAPID RECHARGE TECHNOLOGY
Recharges the jump starter from the vehicle in just 40 seconds
AUTOMATIC VOLTAGE DETECTION
Detects the vehicle’s voltage when the clamps are connected and automatically selects 12 or 24 volt
WORKSHOP TOUGH
Features a tough steel chassis and aluminium housing with a chemical resistant rubber overmold. Includes docking station ideal for workshop use
LCD COLOUR SCREEN
Clear screen provides the user with information such as battery voltage and diagnostic information
Engineered to last
Technical Specs
KEY SPECIFICATIONS
RECHARGE CABLE
BATTERY CAPACITY
2 x 6.0Ah, at 12.8V, 48,000mAh at 3.2V (153.6Wh)
BATTERY CYCLES
2000
BATTERY CHEMISTRY
Lithium (LiFePO4)
CLAMP POWER
12V 1000A / 24V 850A maximum current available at the clamps
PEAK AMPS
3000A
RECHARGING VIA
240V Charging Dock (15V 2A AC Adaptor)
RECHARGING SOURCE
RRT via vehicle starting battery
VOLTAGE
12V and 24V
OPERATING TEMPERATURE
-20°C to 60°C
OPERATING TEMPERATURE (CHARGING)
0°C to 45°C
STORAGE TEMPERATURE (LONG TERM)
-10°C to 45°C
APPLICATION
Industrial and commercial
TYPES OF VEHICLE
Starts large 12V 12.0L petrol & diesel vehicles, and all 24V petrol & diesel vehicles
VEHICLE VOLTAGE RANGE
1 – 14.6V DC (12V DC Vehicle), 14.7 – 30V DC (24V DC Vehicle)
JUMP STARTER LEADS - LENGTH
Positive: 1500mm Negative: 1500mm
JUMP STARTER LEADS - CABLE
50mm² / AWG 0
REVERSE POLARITY PROTECTION
Short-circuit, over-current, input over-voltage and under-voltage, output over-voltage and under-voltage
OVERLOAD PROTECTION
MCU controlled with mechanical delay
POLARITY PROTECTION
MCU controlled with mechanical delay
NO. OF EMERGENCY JUMP STARTS
Unlimited with Rapid Recharge Technology®
DIMENSIONS & WEIGHT
Dimensions
326 x 366 x 170mm
Weight
10.6kg
WARRANTY
Warranty
2 Year Warranty
RECHARGE CABLE
USB OUTPUT
USB LOW VOLTAGE DISCONNECT
OUTLETS
BATTERY CAPACITY
2 x 6.0Ah, at 12.8V, 48,000mAh at 3.2V (153.6Wh)
BATTERY CYCLES
2000
BATTERY CHEMISTRY
Lithium (LiFePO4)
CLAMP POWER
12V 1000A / 24V 850A maximum current available at the clamps
PEAK AMPS
3000A
RECHARGING VIA
240V Charging Dock (15V 2A AC Adaptor)
RECHARGING SOURCE
RRT via vehicle starting battery
VOLTAGE
12V and 24V
OPERATING TEMPERATURE
-20°C to 60°C
OPERATING TEMPERATURE (CHARGING)
0°C to 45°C
STORAGE TEMPERATURE (LONG TERM)
-10°C to 45°C
APPLICATION
Industrial and commercial
TYPES OF VEHICLE
Starts large 12V 12.0L petrol & diesel vehicles, and all 24V petrol & diesel vehicles
VEHICLE VOLTAGE RANGE
1 – 14.6V DC (12V DC Vehicle), 14.7 – 30V DC (24V DC Vehicle)
JUMP STARTER LEADS - LENGTH
Positive: 1500mm Negative: 1500mm
JUMP STARTER LEADS - CABLE
50mm² / AWG 0
REVERSE POLARITY PROTECTION
Short-circuit, over-current, input over-voltage and under-voltage, output over-voltage and under-voltage
OVERLOAD PROTECTION
MCU controlled with mechanical delay
POLARITY PROTECTION
MCU controlled with mechanical delay
NO. OF EMERGENCY JUMP STARTS
Unlimited with Rapid Recharge Technology®
IP RATING
Dimensions
326 x 366 x 170mm
Weight
10.6kg
Warranty
2 Year Warranty
Everything you need
What's in the box?
12/24V 3000A Jump Starter
AC Charging Adaptor
15V 2A AC Charging Adaptor to connect to the charging dock
Charging Dock
Set and forget docking station for the jump starter to be on charge during storage so it is ready for use at anytime.
Instruction Manual
Step-by-step instructions and safety tips.
In the wild
The Feed
Join the community
