12V 1200A Intelli-Start Emergency Lithium Jump Starter and Power Bank

RAPID RECHARGE TECHNOLOGY

Recharges the jump starter from the vehicle in just 40 seconds

• We offer free shipping on orders over $150 AUD (after discounts, before shipping).
• Exclusions: Free shipping does not apply to Dangerous Goods or Bulky Goods.
• Orders Under $150: A flat $12.99 AUD shipping rate applies.
• Dispatch Timeframes: Orders are typically dispatched within 1 business day.
• Delivery Timeframes: Estimated delivery is 2–5 business days after dispatch. Actual delivery times vary based on your location within Australia. Deliveries outside metropolitan areas may take longer.

WHY DIDN’T MY JUMP STARTER START MY VEHICLE?

There could be a number of reasons why the Jump Starter did not start your vehicle.

Check the following:
1. Ensure the Jump Starter battery is fully charged. Refer to page 8 (‘Battery Status Indicator’) for further information.
2. Ensure you have followed the correct operating procedure. Refer to page 7 (‘Jump Starter Instructions’).
3. Ensure the vehicle operates on 12V DC.
4. Ensure the vehicle being jump started is in the specified vehicle engine size of the Jump Starter. For IS920C up to most 6.0 litre petrol vehicles and for IS1220C up to most 7.0 litre petrol vehicles and 4.5 litre diesel vehicles.

CAN I LEAVE MY JUMP STARTER CONNECTED TO THE CAR AFTER IT HAS STARTED?

Yes. The Jump Starter is using Rapid Recharge Technology (RRT) that can rapidly recover charge from the vehicle’s alternator. Leaving the clamps connected to the vehicle for at least 40 seconds after starting the vehicle will recharge the Jump Starter to 100% of the original charge status. Once the Jump Starter is fully charged the RRT will shut off and the user can disconnect the Black clamp and then the Red clamp.

HOW OFTEN SHOULD I CHARGE MY JUMP STARTER?

The Jump Starter uses Lithium technology which self-discharges only a very small amount. To be safe, the Jump Starter should be charged at least every year to be sure it is ready in case of an emergency.

CAN I CHARGE THE JUMP STARTER AND USE THE USB OUTPUT AT THE SAME TIME?

Yes, the USB output can be used at the same time as charging via the USB input. However, the USB output is disabled if the Jump Starter is charging using RRT.

WHAT IS PEAK AMPS?

Peak amps is the maximum current the battery in the Jump Starter can produce.

WHAT IS CLAMP POWER?

Clamp power is the maximum current available at the clamps to start the vehicle.

WHY ISN’T MY JUMP STARTER CHARGING?

The Jump Starter will not charge or perform Rapid Recharge above 45°C. If the alternator is above 14.6V or faulty, Rapid Recharge will not work.

Download Instruction Manual